Albrecht AE125H Specifications download pdf (Page 76)

76 English

The scanner's BNC connector makes it easy to connect a variety of

optional antennas, including an external mobile antenna or outdoor base

station antenna.

Note: Always use 50-ohm, RG-58, or RG-8, coaxial cable to connect an

outdoor antenna. If the antenna is over 15 m from the scanner, use RG-8

low-loss coaxial cable. If it is less than 15 m, use RG-58.

Connecting an Earphone/Headphone

For private listening, you can plug a 3.5 mm mini- plug earphone or

stereo headphones (not supplied) into the headphone jack on top of your

scanner. This automatically disconnects the internal speaker.

Connecting an Extension Speaker

In a noisy area, an optional extension speaker, positioned in the right

place, might provide more comfortable listening. Plug the speaker

cable's 3.5-mm mini-plug into your scanner's jack.

WARNING! If you connect an external speaker to the scanner's

headphone jack, never connect the audio output line to a power

supply and ground. This might damage the scanner.

Adjusting the Belt Clip

The factory-attached belt clip makes it easier to carry the scanner. Use a

Phillips screwdriver to adjust (loosen) the mounting screws or remove

the belt clip completely.

Powering the Scanner

You can power the scanner using alkaline (ALK) non- rechargeable

batteries (not supplied) or the included Nickel Metal-Hydride (Ni-MH)

rechargeable batteries. [Alan provides a USB cable to charge the Ni-MH

batteries on initial installation and to recharge them through your

computer or through a power adapter that provides USB charge power.]

Inside the battery compartment is a switch to set the unit to either ALK or

Ni-MH.

WARNING! Non-rechargeable batteries can get hot or burst if you

try to recharge them.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 175 176

No comments

Albrecht AE125H Specifications Page 76