Albrecht PMR 446 User Manual download pdf (Page 3)

5. Programming the CONTACT 2

Attention!

If the customer wishes that default

settings should remain in the radio under CH

locations 1 to 8, you will have to read the

default setting from the radio now. In this

case you have to start the programming of

additional settings from line 9 of the

programmer window.

There are 20 setting lines available for

individual customer wishes. It is a frequency

range of 446MHz to 448MHz with a channel

spacing of 6,25kHz for the frequency settings

programmable.

Take care that you use a “dot” for the

frequency settings (i.e.: 446.00625)!

There are 38 CTCSS (analogue codes) or 104

DCS (digital codes) for each channel possible.

The device will start by this channel settings,

when you switch the radio on.

You have the choice between H (high) and L

(low) in the radiation power setting step. High

is the maximum technically possible power

(about 2,5W to 3W depending on the used

batteries). Low is the default power setting

(max. 500mW).

Take care! If the customer want to use the

full power option, the batteries will be

discharged much earlier than in the case of

the default Low radiation power. Please note

that the PMR 446 standard setting is L (500

mW) by European regulations.

1 2 3 4

Programming Set 1

Comments to this Manuals

No comments